E39-Engine

The stock pivot pin is made of plastic and over time, from use and heat cycles, the pin can wear down to a nub or shatter completely leaving you st...

Freshen up your engine bay with this OEM BMW ///M logo oil cap. This is also a great addition if your current oil cap does not seal properlly anymo...

We recommend this relay harness for wiring in single or dual high flow fuel pumps. This harness was built with the BMW 3-series in mind.  Wires ar...

If you know you know.  BMW used to this blue braided hydraulic clutch hose on all their cars, but recently superseded it to a generic (lower qualit...

Hose clamps, hose clamps, we could have a whole discussion on these, but when it comes down to it, the last thing you want to do is use cheap big b...

I love goooooold. This high quality gold heat tape is the perfect solution to wrap and protect wires, cables, hoses, fuel lines, intakes, charge pi...

Looking to upgrade your plastic pulleys for lightweight aluminum? The stock pulleys on these BMW engines become brittle and break with use and heat...

Fuel starvation in high g corners, especially below a half tank, can be a major problem on track with your E30 or E36. This problem has now been s...

This little gasket may seem small, but it can cause a lot of leaks.  This gasket fits between your engine block and your oil filter housing.  These...

Changing oil is an inevitable necessity on not just BMWs but all cars. It is not always the most glamorous job, but it must be done. If this is a...

Looking to have your BMW fuel injectors rebuilt but don't think you have the tools or are up to the task?  No problem.  We are now offering an inje...

Finding an easy solution to tap into the oil system can often be a challenge but look no more. This vanos banjo bolt to AN fitting is the perfect s...

There are not many times we have purchased a used BMW, and these BMW beauty cover caps are in place.  With the caps missing, it leaves an unsightly...

Are you adding a custom exhaust to your BMW or repairing your old one?  You might need to add a custom O2 sensor exhaust bung.  These high quality ...

Looking for an alternative to the plastic solid motor mounts on the market?  Revshift came out swinging and is now announcing their solid drift mou...

A popular upgrade on BMWs is to switch from a 3" MAF to a 3.5". The 3.5" MAF can be found on 540i, 740i and some porsche models. To accomplish thi...

These gaskets fit at the end of your headers to your exhaust midpipe.  Replace yours with these high quality OE replacements. Kit Includes 2 gasket...

One of the most popular modifications on the OBD2 M52 engines, is to M50 manifold swap it from an earlier OBD1 version.  The M50 manifold has short...

Leaky oil pan gasket? This is a common issue on higher mileage BMWs.  Replace your gasket and get those oil stains off your garage floor with this ...

Chase Bays BMW M50/M52/M54/S50/S52 Vanos Oil Line

Modern day injectors are very reliable, but after 10-30 years of abuse they do wear out.  Old injectors can stick, get clogged, or fail all togethe...

If your thermostat housing is leaking, it is most likely this gasket.  This fits in the groove of your thermostat housing which sandwiches between ...

Have a tight clearance on your headers?  The stock copper exhaust nuts can cause issues on some aftermarket headers and turbo manifolds.  Our low p...

If you're looking to add that little extra touch to your engine bay, then our deluxe exhaust stud nuts may be what you're looking for. These exten...

This aluminum heat tape is flexible with a super strong adhesive backing. This will thermal insulate up to 2000 degrees F. Made of one mil aluminiz...

We never stop looking for the best possible products for your car. Having a magnetic drain plug for your oil is essential in not only alerting you...

We never stop looking for the best possible products for your car. Having a magnetic drain plug for your oil is essential in not only alerting you ...

Replacing your engine air filter in a BMW is common maintenance, but unfortunately these little spring clips can be hard to remove.  At times they ...

A common issue on the S6S420G transmission from the E46 M3 and E39 M5 is slop from the 5th and reverse gear.  BMW realized this, and made a solutio...

The Revshift M3 exhaust hanger insert is made from our 80A polyurethane. This part fits into the oem exhaust hanger. It prevents the hanger from sa...

This is a common crush copper crush washer gasket used all over the BMW engine. The most used application for this gasket is for the radiator auxil...

The accessory belt tensioner assembly is a crucial part to your engine that creates tension on your main serpentine belt.  Most times, the bearing ...

BMW has been using this shifter cup in almost every generation BMW.  If your shifter feels sloppy or loose, it could be a worn shifter cup.  These ...

There is no mistaking the 6 speed ZF transmission that came in the E46 330i ZHP, M3, and E39 M5 were great transmissions.  They can hold a lot of p...

Looking for the perfect companion to your Kinematic Speed Race shifter? Look no further with their brand adjustable selector rod.  Tailor your shif...

Added by popular demand, our deluxe magnetic drain plugs are now kitted. Not only do you receive an oil drain plug, differential plug, and trans p...

The rear main seal on our BMWs commonly leak and should be replaced.  It is also recommended to replace this seal anytime you remove the transmissi...

Exhaust leak? Replace your gaskets with this high quality OE replacement. *Sold Individually (2 required per 6 cylinder car) Replaces BMW PN  1162...

The oil pressure switch monitors your BMW's engine oil pressure.  A leaking or failed sensor switch can be disastrous and lead to engine failure. M...

Leaky valve covers are common, and can cause many issues including vacuum leaks and oil leaking down to your headers.  Replace your hardened gasket...

Modern day injectors are very reliable, but after 10-30 years of abuse they do wear out.  Old injectors can stick, get clogged, or fail all togethe...