E39-Data & Electrical

Here is a simple solution for adding an aftermarket coolant gauge. This adapter is machined out of aluminum and splices into your upper radiator ho...

Resetting your service and oil light on your BMW can be a hassle. Some jumper pins on the 20 pin connector to make this work. Now its a lot easier....

The stock auxiliary fan on our BMWs don't actually push that much air, so a common upgrade is to replace it with a high flow SPAL electric fan.  We...

We probably get more questions about how to wire up an electric fan properly than anything else. Because of this, we put together a SPAL EZ fan rel...

This little cable is a must if you 24V swapped your E30. The E36 engine harness has a 20 pin service port. This adapter allows you to hook up to th...

If you are looking for a way to tap into your coolant system to install an aftermarket temperature gauge, than look no further. We use a brand new...

This is by far the easiest way to add an aftermarket oil pressure gauge to your BMW. The supplied stainless steel banjo bolt attaches this machined...

Your standard OBD2 readers can only read basic codes. They are not able to read BMW specific engine codes. This can be crucial in diagnosing your e...

Being able to read your oil pressure is a great idea for any performance car. This VDO oil pressure sender allows you to add an aftermarket VDO oi...

How many times have you been on track and your GoPro is recording your best session, and your battery dies? Never let this happen again with the ...

Mixing the best of both worlds. Our regular tapped aluminum thermostat housing has become a fan favorite to easily add an aftermarket coolant gauge...

Most of the time, the places you need to tap into the oil system aren't in the greatest position. It is usually in a spot that is hard to get to. ...

There is no denying that SPAL electric fans are a great upgrade over the stock electric fan or mechanical clutch fun. But purchasing the fan is onl...

The VDO M12x1.5 temperature sender is exactly what we use to screw directly in the head of most BMW engines to read the coolant temperature. This ...

This simple adapter will help you install a 1/8npt sensor into your obd2 BMW head. Made of 6061 aluminum in the USA.  Do not overtighten adapter. S...

Unfortunately, the VDO black series gauge we have known to love in the BMW community is no longer available.  VDO has now replaced it with their Si...

The VDO temperature sender is used to add an aftermarket coolant temperature gauge to your car. This simple sender reads the temperature of your c...

Finding a way to measure your fuel pressure is not always the easiest thing to do. We wanted to make your life just a little easier with this in-l...

Finding an easy solution to tap into the oil system can often be a challenge but look no more. This vanos banjo bolt to AN fitting is the perfect s...

Upgrading to a SPAL electric fan is a must have for any BMW.  There is no doubt the BMW cooling system lacks, and the SPAL aftermarket electric fan...

On the M52 (OBD2) intake manifold, BMW uses this inlets air temperature sensor to measure the temperature of the air and send it to the DME for fue...

A very common failure on BMWs.  When this resistor fails, your HVAC blower fan will no longer work.  Many people think it may be the actual blower ...

On the M52 (OBD2) intake manifold, BMW uses this inlets air temperature sensor to measure the temperature of the air and send it to the DME for fue...