E21-Engine

OVER 1000 KITS SOLD! Have low fuel pressure or rough running engine? Have leaks or broken pintle caps? It may be time to rebuild your fuel injector...

*NOW OFFERING EXTENDED STUDS FOR AFTERMARKET HEADERS Installing the OEM exhaust manifold studs can be a real pain. Since the stock studs do not hav...

I believe its almost impossible to remove the injector harness and not lose one of these clips. On top of that, when one pops off, it falls into th...

*NOW OFFERING EXTENDED STUDS FOR AFTERMARKET HEADERS Have you ever gone to remove an exhaust stud and the stud and nut comes out as a pair? Have tr...

Are you looking to push some serious air? There is no denying that BMW does not always have the best cooling systems. In fact one of the first thin...

NEWS! We just upgraded to a top of the line ASNU fuel injector flow bench for the most accuracy and fastest turn around times.  The health of your ...

If you have been following Race German for a while, you know I have an aviation background. Aviation products hold a higher standard for obvious re...

These copper corrosive resistant nuts are the perfect combo for our upgraded exhaust studs. Anytime you change your headers, you should replace you...

These universal BMW injector retainer clips commonly fall into your engine bay where there is no retrieving.  Replace your lost or corroded clips w...

A very popular upgrade for track cars. By replacing your original 92 degree thermostat with a 80 degree thermostat, you are allowing the coolant to...

Replacing your old, worn out injectors is a very good thing.  Unfortunately, many of these clips are rusted, or get lost in the engine bay.  Good l...

We probably get more questions about how to wire up an electric fan properly than anything else. Because of this, we put together a SPAL EZ fan rel...

This is the correct vacuum hose for your BMW. Do not try to use the standard size (1/8, 3/16, 1/4) vacuum lines from your local automotive store. T...

One of the biggest causes of check engine lights is vacuum leaks. The OEM rubber vacuum line gets brittle from the heat and the cracks cause leaks....

A very popular upgrade for track cars. By replacing your original 92 degree thermostat with a 71 degree thermostat, you are allowing the coolant to...

Over the years of the engine bay heat cycling, the injector plugs can become worn and brittle.  When this happens, the plugs can break, leaving you...

Poly transmission mounts are a great way to tighten up your shifting experience. We have tested many mounts over the years and believe Revshift mak...

There is no denying that SPAL electric fans are a great upgrade over the stock electric fan or mechanical clutch fun. But purchasing the fan is onl...

Most of the time, the places you need to tap into the oil system aren't in the greatest position. It is usually in a spot that is hard to get to. ...

Hose clamps, hose clamps, we could have a whole discussion on these, but when it comes down to it, the last thing you want to do is use cheap big b...

I love goooooold. This high quality gold heat tape is the perfect solution to wrap and protect wires, cables, hoses, fuel lines, intakes, charge pi...

Fuel starvation in high g corners, especially below a half tank, can be a major problem on track with your E30 or E36. This problem has now been s...