A/C Solutions

Designed specifically for the early model E30, this R134a A/C line is a direct replacement of your original high-pressure condenser to drier return...

Designed specifically for the E30, this line set is a direct replacement of your original interior lines allowing you to properly run R134a. While ...

For use on all E30 models, this hardware kit is designed to provide the necessary brackets, bolts, body mounts, and hose clamps to support the A/C ...

Designed specifically for the late model E30 M3, this R134a A/C line is a direct replacement of your original high-pressure condenser to drier retu...

Designed specifically for the early model E30 M3, this R134a A/C line is a direct replacement of your original high-pressure condenser to drier ret...

Designed for 24v swapped E30s, this R134a line set and Denso manifold provides you with the bare minimum to retain A/C in your S5x or M5x powered E...

Designed with originality in mind, this kit is used to fit the Sanden 508 compressor (SD5H14) to the S14 or M10 engine block using a fully isolated...

Specific to R134a, this high tonnage expansion valve is designed to replace your original R12 expansion valve and is a highly recommended replaceme...

The high-pressure cut off switch is used to disengage the A/C compressor when the system reaches maximum pressure. Unlike your original switch, thi...

The filter drier is designed to keep the system clean and clear of debris and moisture and should be changed any time the A/C system is opened for ...

Designed specifically for the E28, this R134a A/C line is a direct replacement of your original high-pressure condenser to drier return line. What'...

The filter drier is designed to keep the system clean and clear of debris and moisture and should be changed any time the A/C system is opened for ...

Designed for the Porsche 911 Carrera 3.2 and 911/930 Turbo, this kit provides the o-rings needed to convert your factory A/C system to R134a. What'...

Designed for the enthusiast, this all new R134a A/C line set used to replace your old R12 lines and allow you to run a Sanden compressor in your BM...

For use on all E28 models, this hardware kit is designed to provide screws, nuts, body mounts, and hose clamps to support the A/C lines, condenser,...