E39 N52/N54 Swap Harness Adapter

*Note: Comes with CanBus emulator.

N52 must use MSV70 DME (2006-2007)
N52N must use MSV80 DME (2007-2013)
N54 must use MSD80/MSD81 DME

These Plug-and-Play wiring solutions will make your engine conversion a breeze.
These wiring kits use all new components. All crimp terminals and connectors are new. These kits are made with high temperature automotive grade wiring that resist oils, grease, and acids.

Continuity tested on every wire during construction. Wrapped in high temperature expandable nylon sheathing to resist abrasion.
Instruction sheets are included with every harness kit.

The CAN-Bus emulator is a must for this swap to prevent the DME from going into limp mode. This emulator simulates the missing E60/E61 and E90/E91/E92/E93 chassis computers.

These adapters include the following:

• OBD2 diagnostic port
• Electronic pedal wiring
• Fuel pump wiring and relay
• CAN-Bus Emulator

Requires the following matching set:
– Engine Computer
– CAS Module and ribbon
– Ignition Key with reader

EWS (Immobilizer) delete is now possible. However, we do not offer this service at the moment. Contact us for more details if this is something of interest.

**Adapters are made to order. Please allow up 2-3 days for completion.**

**All adapter sales are final. Since they are made specifically for your vehicle, there will be no refunds.**